Ferm AGM1067P Traducción Del Manual Original página 9

Technical specifications
Model No AGM1067P AGM1068P AGM1072P
Mains voltage
Mains frequency
Power input
750W
Rated speed
Wheel disc for grinding
Diameter 115 mm
Bore 22 mm
Spindle thread M14
Weight
Sound pressure (L )
PA
Acoustic power (L )
WA
Vibration "Surface
grinding" a
h,AG
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in
EN 60745; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
• using the tool for different applications, or with
different or poorly maintained accessories,
may significantly increase the exposure level
• the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
pages 2-3
Fig. A
1. Spindle lock button
2. On/Off switch
3. Protection guard
220-240 V~
50 Hz
850W
750W
11.000 /min
125 mm 100 mm
22 mm 16 mm
M14 M10
1.9 kg
89 + 3 dB(A)
100 + 3 dB(A)
11.2 + 1.5 m/s
2
Fig. B
8. Spindle
9. Mounting flange
10. Wheel disc (not included)
11. Clamping nut
12. Spanner
13. Side handle
Assembly
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Assembling the protection guard
(Fig. A and B)
• Place the machine on a table with the spindle
(8) facing upwards.
• Place the protection guard (3) over the
machine head as shown in Figure C making
sure the ridges on the protection guard fall into
the notches of the machine head.
• Turn the protection guard counter clockwise
and secure the guard by tightening the screw
(14).
Never attempt to remove the guard.
Mounting and removing the wheel disc
(Fig. B)
• Always use suitable wheel disc for this
machine with diameter Ø 100 / 115 / 125 mm
and a bore from 22 / 22 / 16 mm the thickness
of the wheel disc should be 6 mm for wheel
disc for grinding and 3 mm for wheel disc
for cutting, the mounting wheel disc may not
touch the safety guard.
Mounting
• Place the machine on a table with the
protection guard (3) facing upwards.
• Mount the flange (9) onto the spindle (8).
• Place the wheel disc (10) onto the spindle (8).
• Keep the spindle lock button (1) pressed and
firmly tighten the clamping nut (11) onto the
spindle (8) by using the spanner (12).
Removing
• Place the machine on a table with the
protection guard (3) facing upwards.
9