Setup The Console - Bresser Tuya Smart Manual De Instrucciones

SETUP THE CONSOLE

INSTALL THE BACKUP BATTERY
Backup battery provides power to the console to retain clock time and date, max/min records and
calibration value .
Remove the console
battery door with coin
NOTE:
- The backup battery can back up: Time & Date, Max/Min records and calibration value .
- The built-in memory can back up: Router setting server settings .
POWER UP THE CONSOLE
1 . Plug in the power adapter to power up the console .
2 . Once the console is power up, all the segments of the LCD will be shown .
3 . The console will automatically enter AP mode and sensor synchronization mode automatically .
Blinking:
Sensor synchronization
process
4 . The wireless sensor will automatically pair up with console (about 1 minute) . Upon successful
synchronization, display will change from "-- .-°C --%" to actual reading .
NOTE:
If no display appears when power up the console . You can press [ RESET ] key by using a pointed
object . If this process still not work, you can remove the backup battery and unplug the adaptor then
re-power up the console again .
RESET AND FACTORY HARD RESET
To reset the console and start again, press the [ RESET ] key once or remove the backup battery
and then unplug the adapter . To resume factory settings and remove all data, press and hold the [
RESET ] key for 6 seconds .
CHANGING BATTERIES AND MANUAL PAIRING OF SENSOR
Whenever you changed the batteries of the wireless sensor, re-synchronization must be done
manually .
1 . Change all the batteries to new ones in the sensor .
2 . Press [ SENSOR / WI-FI ] key on the console to enter sensor Synchronization mode .
3 . Console will re-register the sensor after its batteries are changed (about 1 minute) .
Step 1
Insert a new CR2032
Step 2
button cell battery
26
Step 3
Replace the battery door .
Flashing:
Console currently in Access
Point (AP) mode
Blinking:
Trying to connect to router
Stable:
Connected to router
Stable:
Connected to router and
synchronized to local time