Trouble Shooting; Device Maintenance - VISIOMED BABY Doo Cleaner MX-ONE Manual Del Usuario

- Regular instillations of sterilized seawater or physiological saline solution–
they properties are rather similar – help liquefy secretions and unclog the
nose. Make sure the saline solution is at room temperature. The instillation
should be practiced with the head on the side, in lying position. Never
perform an instillation with the head back.
- When using a saline solution (such as seawater, physiological saline so-
lution...), a large amount of liquid mixed with the secretions may fall in
the bronchia. Make sure that liquid mixture is fully removed using the
BABYDoo .
® IT IS ADVISED TO CONSULT YOUR DOCTOR:
WHEN IN DOUBT ABOUT YOUR CHILD'S HEALTH
WHEN IN DOUBT AS TO THE USE OF THIS DEVICE
- After each use, throw the hygienic caps.
- Clean the device with soapy water.
- Do not immerse the whole of device in any liquid.
- Sterilize the BABYDoo MX-One once a day in case of regular use but do
®
not sterilize the battery compartment.
- Do not sterilize the accessories in a microwave.
20 Visiomed BABYDOO MX-ONE - V5 - 012017

TROUBLE SHOOTING

If one of the following problems arises when using your baby nose cleaner
BABYDoo MX-One, refer to this trouble shooting guide. If the problem
®
persists, please contact our customer support at +33 892 350 334.
Problems
No suction
Water leak or accumulation in the
cover
Nothing happens when you press
the switch button

DEVICE MAINTENANCE

- Clean BABYDoo MX-One with soapy water.
®
- You can cold sterilize the removable section of the BABYDoo
well as the accessories (probes and joints).
- Do not sterilize the accessories in a microwave.
- Use a dry and soft cloth to clean the main unit. If necessary, use a damp
cloth.
- Never use alcohol, benzene, thinners or other chemicals to clean the
device.
- Avoid placing the unit in direct sunrays, high humidity or dust.
Note : if the device is not used for an extended period, make sure the bat-
teries are removed (they could damage the device).
Visiomed BABYDOO MX-ONE - V5 - 012017
Solutions
- Check the sealing joint (position,
wear...).
- Check the sealing of the device :
the 4 notches of the cover and the
main unit must face each other.
- Check the position of the cover.
- Check the position of the silicone
prob.
- Check that the air inlet is not
blocked.
- Check the sealing of the device :
the 4 notches of the cover and the
main unit must face each other.
- Check the cover is not upside-down.
Check the batteries (polarity, wear...).
MX-One, as
®
21