Adding A Link To Pt Hardware - Permobil BODILINK Guía De Usuario

INSTALLATION - ADDING LINKS, WING LOCK

Adding a Link to PT Hardware

Note: The provided extra 2", 3", or 4" link may be used to reach extreme positions. Taper inserts may be
oriented so screws face either left or right.
1
Remove the screw (A) and the safety washer (B) from the taper insert (C). Separate the link (D)
and the ball link (E).
2
Align the new link (F) with the link (D).
3
Place the existing taper insert (C) halves (countersunk side first) in the end of link (D). Make
sure the square ends are aligned inside for a low-profile fit in the joint. The countersunk side of
all taper inserts (C) should face the same direction on the hardware so that the screws (A) are
all on the same side.
4
Insert the screw (A) and the safety washer (B) into the countersunk side of the taper insert (C)
and tighten. Firmly hold the threaded side of the taper insert (C) while tightening.
5
Align the new link (F) joint with the ball link (E).
6
Place the new taper insert (G) halves (countersunk side first) in the end of the ball link (E). Make
sure the square ends are aligned inside for a low-profile fit in the joint.
7
Insert the screw (H) and the safety washer (J) into countersunk side of the taper insert (G) and
tighten. Firmly hold the threaded side of the taper insert while tightening.
B
A
BodiLink Head Support User Guide & Manual
E
C
D
A
E
F
C
B
D
13
E
G
J
H F