Installation - Adding Links, Wing Lock; Adding A Link To Gt Hardware - Permobil BODILINK Guía De Usuario

INSTALLATION - ADDING LINKS, WING LOCK

Adding a Link to GT Hardware

Note: The provided extra link may be used to reach extreme positions.
WARNING: Adding additional links to the hardware may reduce the
overall strength.
1
Remove the screw (D) and the safety washer (E) to separate the curved
link (F) from the top of the hardware stem (C).
2
Remove the hardware stem (C) from the mounting block (B) by turning
the knob (A) counterclockwise.
3
Turn the hardware stem (C) 180° so the visible gear teeth are facing the
opposite direction.
4
Insert the hardware stem (C) into the mounting block (B) and turn the
knob (A) clockwise to secure.
IMPORTANT! Make sure that at least ½" of the hardware stem (C) is
completely through the bottom of mounting block (B) at all times. See the
warning in the "Important Safety Information" section in this manual.
5
Align the extra link (G) with the gear teeth on the hardware stem (C) in the
orientation shown, and fasten with the safety washer (H) and the screw (J).
6
Align the other end of the extra link (G) with the curved link (F) and fasten
with the safety washer (E) and the screw (D).
7
See SUPPORT PAD installation, positioning and adjustment instructions in this
manual to make final adjustments.
WARNING: Make sure that the teeth on all link joints are properly
aligned and engaged before final tightening. Failing to do so could cause
wear on the teeth, leading to parts slipping out of adjustment or hardware
failure. (GT Hardware only)
Gear Teeth Alignment
BodiLink Head Support User Guide & Manual
C
C
B
2
F
D
E
1
G
H
J
5
12
3
A
4
F
E
6
C
D