Operating Instructions; Operating Control Panel; Heater Control; Temperature Control - Napoleon NEFI18H-HD Instrucciones De Instalación Y Operación

4.0 OPERATING INSTRUCTIONS

Once the log set has been plugged into a grounded electrical outlet or hard wired to a dedicated grounded
120V power supply, it is ready to operate.
ATTENTION: Ensure the house circuit breakers for the power supply are turned on. When initially
connecting the appliance into a power source, the appliance will perfom an LED check. The appliance
will flash on and off for 5 seconds then remain off until turned on by control panel or remote.
4.1

OPERATING CONTROL PANEL

The Control Panel is located on the front of the log set.
Power
Flame & Ember Light
Control

Heater Control

Timer
F° / C° Switch
Heater Lock
Temperature
Control
Turns the appliance ON/OFF.
Controls Flame brightness and the Ember Light.
5 Settings: Flame & Ember off (FO), Ember on but Flame
off (LL), small Flame & Ember (F1), medium Flame &
Ember (F2), brightest Flame and Ember (F3).
Default setting is (F3).
Turns the Heater and Blower ON/OFF.
4 Settings: Heater & Blower off (HO), Blower on (BL), low
heat (H1), high heat (H2).
Default setting is (HO).
Timer can be programed to run appliance for specific
lengths of time (30mins. minimum to 6hrs maximum).
Default setting is Timer de-select.
To change temperature format, Fahrenheit or Celsius.
Hold 5
Press and hold the Flame button
seconds
Default setting is Fahrenheit.
Heater button can be locked or unlocked by holding the
Hold 5
Heater button for 5 seconds.
seconds
Default setting is heater unlock
Press and hold the Timer button
Hold 5
will change the button to Temperature Control, or vice
seconds
versa. There are 7 temperature settings (61
75 F, 81 F, 85 F and OFF).
° ° °
Default setting is de-select Temperature Control.
for 5 seconds.
for 5 seconds. This
F, 64 F, 70 F,
° ° °
W415-1754 / A / 06.08.17
11
EN