Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Gen ConF: General Parameters
Process Set Value Low Limit (
Process Set Value Up Limit (
Alarm Set Values Protection
Alarm Set values can be changed.
Alarm Set values can not be changed. Alarm set values
Parameters (
AUTO / MANUAL Selection Button Protection
Auto or Manual selection is possible with A/M button in
Main Operation screen.
Auto or Manual selection is not possible with A/M button in
Main Operation screen.
AT (AUTO TUNE) Button Protection
Limit Cycle Tuning operation can be active or inactive with
AT(Auto Tune) Button in Main Operation screen.
Limit Cycle Tuning operation can not be active or inactive with
AT(Auto Tune) Button in Main Operation screen.
PASS ConF: Technician Password
Technician Password (0, 9999)
It is used for accessing to the technician parameters.
It can be adjusted from 0 to 9999.
If it is
; there is no password protection while entering to
the technician parameters.
If this parameter is different from " 0" and user wants to
access to the technician parameters;
1- If technician does not enter
It turns to operation screen without entering to technician
parameters.
2- When
technician presses SET button without entering password (For
observing parameter)
Technician can see all menus and parameters except Technician
Password menu ("Pass Conf"), but parameters can not be
changed.
and
) are not accessible.
in top display and
,
)Unit
,
)Unit
password correctly:
in bottom display, if
15
Tabla de contenido
