Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ASSEMBLY STEP 2
CONSOLE CABLE
(THREAD THROUGH INSIDE HOLE IN MAST)
RIGHT CONSOLE MAST
CONSOLE MAST SUPPORT TUBE
BOLT (A)
LOCK WASHER (B)
WASHER (C)
HARDWARE bAG 2
LOCK WASHER (B)
WASHER (C)
BOLT (A)
BOLT (D)
DECK LOCK LATCH
LEFT CONSOLE MAST
A
Open HARDWARE bAG 2.
CONTENTS :
NOTE: While assembling the masts, do
not completely tighten any bolts until
BOLT (A)
15 mm
the end of ASSEMBLY STEP 3. Ensure
Qty: 8
that ALL bolts are in place and partially
threaded in before completely tightening
LOCK
WASHER (B)
any ONE bolt.
Qty: 8
NOTE: Be careful not to pinch any wires
WASHER (C)
Qty: 8
while assembling the masts.
B
Slide the RIGHT CONSOLE MAST
BOLT (D)
20 mm
down onto the CONSOLE MAST
Qty: 2
SUPPORT TUbE. Bolt in place using 2
bOLTS (f), 2 LOCK WASHERS (b),
and 2 WASHERS (C) on the side. Then,
bolt in place using 2 bOLTS (f), 2 lock
WASHERS (b), and 2 WASHERS
(C) on the front. NOTE: carefully lift right
console mast to avoid disconnecting
console cable from the motor control
board. The console cable must be
threaded through the mast.
C
Repeat on the other side.
D
Attach DECK LOCK LATCH to LEfT
CONSOLE MAST using 2 bOLTS (D).
7
Tabla de contenido
