Dip Switch And Jumper Settings; Dip Switches - Epson C824431 Manual Del Usario

DIP switch and jumper settings

Before you install the C824431/C824432 interface, you may
need to adjust the DIP switch 2 and jumper settings.
You can change the DIP switch 1 settings after you install
the interface. When making DIP switch setting changes, it is
best to use a pointed device, such as a ball-point pen or
small screwdriver.
Caution
All changes of DIP switch and jumper settings should be
made with the printer power turned off. New settings
become valid only when the printer is turned on.

DIP switches

The settings on DIP switches allow you to change interface
functions. The two sets of DIP switches on the C824431/
C824432 are labelled SW1 and SW2. Each set contains a
number of individual toggle-type switches that can be set
either on or off. The individual switches are referred to by
set (SWl or SW2) and number. Therefore, the switch in set
SW1 marked by the small number 3 is called DIP switch1-3.
5