GE APN08 Manual Del Propietario E Instrucciones De Instalación página 5

The display will always default to show the
room temperature.
COOL Mode
Use the COOL mode for cooling.
To set the COOL mode:
1. Press the MODE pad until the COOL indicator
light is lit.
2. Press the FAN pad to set HIGH, MEDIUM or LOW
fan speed.
3. Press or to set the desired temperature
between 64°F and 90°F in 1°F increments.
After settings have been made, the display will
change back to show the room temperature.
The temperature control is used to maintain the
room temperature. The compressor will cycle on
and off to keep the room at the set level of comfort.
Set the temperature control at a lower number
and the indoor air will become cooler. Set the
temperature control at a higher number and the
indoor air will become warmer.
DRY Mode—Dehumidification
Use the DRY mode to provide dehumidification
only. The fan will run at a fixed speed at this setting,
so a fan speed cannot be set. Keep windows and
doors closed for the best dehumidifying effects.
The exhaust hose must be attached to the unit
when using the DRY mode.
To set the DRY mode:
• Press the MODE pad until the DRY indicator light
is lit.
In the DRY mode, a set temperature will not be
displayed. After DRY mode has been set, the display
will change back to show the room temperature.
FAN Mode
Use the FAN mode to provide air circulation and
filtering without cooling.
To set the FAN mode:
• Press the FAN pad until the desired indicator light
for HIGH, MEDIUM or LOW fan speed is lit.
Power Outage Recovery Feature
In the case of a power outage or interruption, the
unit will automatically re-start in the settings last
used after the power is restored.
When the air conditioner is turned on, it will
automatically start in the last mode and fan settings
selected.
NOTE: If the air conditioner is off and is then turned on
while set to COOL, it will take approximately 3 minutes
for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—Select the COOL mode and
HIGH or MEDIUM fan speed with a middle set
temperature.
For Maximum Cooling—Select the COOL mode
and HIGH fan speed with a lower set temperature.
For Quieter & Nighttime Cooling—Select the COOL
mode and LOW fan speed with a middle set
temperature.
NOTE: If you switch from a COOL setting to OFF or to
a fan setting, wait at least 3 minutes before switching
back to a COOL setting.
NOTE: If you switch from a DRY setting to OFF or to a
fan setting, wait at least 3 minutes before switching
back to a DRY setting.
If using the unit in the DRY mode for an extended time:
1. Unplug the power cord.
2. Roll the unit so that its drain nozzle is located over
a floor drain and pull out the drain cap from the
back bottom edge. A water hose (not included)
may also be attached to the nozzle and led to a
floor drain. Reconnect the power cord.
3. Press the MODE pad until the DRY indicator light
is lit.
Since fan only settings do not provide cooling, a set
temperature will not be displayed. After FAN speed
has been set, the display will change back to show
the room temperature.
NOTE: If the TIMER was set before the power outage,
it will need to be reset after power is restored.
www.GEAppliances.com
5