Elite SUPER CRONO Instrucciones Para El Uso página 27

COMPuTER INsTAllATION
• Open the battery housing under the display and
place the two AA type batteries that are in the
computer box. Observe the polarity indicated on
the batteries housing.
• Attach the computer to the support, as seen in
(fig. 34).
• Connect the cable, that is on the rear side of the
computer, to its correspondent connection loca-
ted on the support (fig. 35).
• Make sure that the computer is securely fixed to
the handlebar and that its position allows a clear
view of the display when pedaling.
• Now it is possible to begin training and to check
all the training data on the display.
COMPuTER usE
SwITCHING ON
• If not already done, insert the batteries in the
computer.
• For computers provided with a switch, turn the
switch to "ON".
• For computers without switch, press one of the
two buttons.
To use the Super Crono Wireless correctly it is
needed to first set the parameters. To do this you
must enter the SET UP screen.
To enter the SET UP screen keep the right button
(MODE) pressed for at least three seconds. The
SET UP message will appear. When the button is
released, the computer shows the first screen of
the SET UP phase.
Attention: it is possible to enter the sET uP
phase only at zero speed. During this operation
we suggest to detach the cable M on the rear side
of the computer.
34
Screen that shows the choice of the measures unit.
The first step is to choose the unit of measure-
ment between the metric and imperial systems.
To do this it is needed to push the left button
(SET). On the screen METER (Meters), KM/H
(Kilometers per hour) and KILO (Kgs) or FOOT
(Foot), M/H (Miles per hour) and lb (Pounds /
ounces) will appear alternatively. By pressing the
MOdE button the units chosen are confirmed and
35
you pass on to the next screen.
Screen for the setting of the athlete's weight.
In the upper part of this screen there is a three
digit number that indicates rider weight plus the
bike weight, shown in the previously chosen
measurement unit. The weight set by the
manufacturer or the last data inserted will appe-
ar. To modify this data, push the SET button to
modify the digit that is flashing and the MODE
button to confirm the chosen value and pass on to
the next digit that will start flashing/blinking.
Repeat the operation to set all three digits of the
weight. Push the MODE button to confirm the
sETTINgs
GB
27