Elite SUPER CRONO Instrucciones Para El Uso página 20

GB
Thank you for choosing the super Crono
Wireless.
The Super Crono Wireless is a completely wire-
less home trainer. All the information is transmit-
ted via radio by the transmission unit to the
computer on a frequency of 433MHz. In order to
avoid possible interference, data transmission is
coded so that only the correct information, rele-
vant to training, is displayed on the computer
(even in the presence of interference on the same
frequency). The coding also enables the simulta-
neous training of several cyclists training with the
Super Crono Wireless.
do not stop the rotation of the bicycle
wheel by using caliper or disk brake. This
seriously damages the roller and the tire.
If the training data is not correctly displa-
yed during the first use, the resistance unit
must be synchronised with the computer
(see the section "Synchronisation").
INTROduCTION
Check the presence of all the following compo-
nents.
1 Wireless Fluid Unit with two AA batteries (Ref. A)
1 Stand (Ref.B)
1 left bushing pin (Ref.C)
1 ring (Ref.D)
1 right bushing pin (Ref.E)
1 control lever (Ref.F)
1 unit support upper base (Ref.G)
1 unit support lower base (Ref.H)
1 screw M6 x45 mm (Ref.I)
20
IMPORTANT
1 washer Ø6 mm (Ref.L)
1 nut M6 (Ref.M)
1 Bag of unit accessories:
1 hex wrench
2 screws M6 x 55 mm (Ref.N)
2 washers Ø6 mm (Ref.O)
1 Quick release (Ref.P)
1 Travel Block (Ref.Q)
1 Receiver (Ref.R)
1 Console with two AA batteries (Ref.S)