Kapriol 27960 Manual Del Usuario página 9

INSTALLING THE 27960 ON A STRUCTURAL ANCHOR ELEMENT
It's possible to instal the 27960 directly on the structural anchor element like flat surface (e.g wall) or steel profile. The structural anchor element to which the 27960 is
fastened must have stable construction and have minimal static strength of 14 kN. Construction and fastening of the structural anchor element must prevent of accidental
dissconnection of the 27960. To instal the 27960 on the structural anchor element we must remove the grip which is designed to be used only for the 27961 tripod.
REMOVING THE GRIP
Screw M10
1. Undo four M10 nuts on the bolts fastened
the grip to the 27960.
INSTALLING ON THE FLAT SURFACE
Picture B
M10 bolts
10
M10 washers
(DIN125-A)
1. The 27960 should be installed using two (ø10 mm and 10
x 50 mm) wholes situated on the back wall of the 27960.
2. Install the 27960 using two M10 steel or chemical anchor
bolts installed in the way shown on the picture B. Put the
washer M10 (DIN 125A) under each nut. Tighten two
M10 self-locking nuts.
POSITIONING OF THE 27960
1. Check the proper position
of the 27960 and correct
guiding of the rope
shown on the pictures D
and E. The construction
element where the
27960 is installed must
be vertical (D) or
horizontal (E).
2. Attach the energy
absorber to the cable
using the connector
suppllied with the
absorber.
2. Remove the bolts. Remove the grip.
M10 self-locking
nuts
(DIN985)
Picture D
Shock absorber
INSTALLING ON THE STEEL PROFILE
Picture C
M10 washers
(DIN125-A)
M10 bolts
(DIN 933)
1. The 27960 should be installed using two (ø10 mm and 10 x 50 mm) wholes situated
on the back wall of the 27960.
2. Install the 27960 using two M10 steel bolts. Put the bolts through the structural anchor
profile and through the back wall of the 27960. Position of the wholes is shown on the
picture C. Put the washers M10 (DIN 125A) under the head of each bolt and under each
nut. Tighten two M10 self-locking nuts (DIN 985).
Picture E
Shock absorber
M10 washers
(DIN125-A)
10
M10 self-locking
nuts
(DIN985)
3) Connect absorber's
connector to the attachment
element of a harness. Use "A"
frontal or dorsal attachment point
in full body harness (EN 361)
or rescue arttachment point
in rescue harness (EN 1497) or
rescue loops (EN 1498).