Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
1
Determining the mounting
location
NOTE: The light fixture should be mounted approximately
8 ft. (2.4 m) above the ground. If the light fixture is
mounted higher than recommended, aiming the sensor
down will reduce the coverage area.
□
Determine the mounting location – wall or eave
mount.
□
Position the lamp heads (A) in the general
direction of the desired light coverage.
2
Removing the mounting plate
NOTE: This fixture comes with a mounting plate (D). It is
pre-assembled on the light fixture (B) for shipping.
NOTE: The large mounting bolt (EE) is pre-installed in
the light fixture (B). Do not attempt to remove the large
mounting bolt (EE).
□
Unscrew the large mounting bolt (EE) connecting
the light fixture (B) to the mounting plate (D) and
remove the mounting plate (D).
B
EE
Wall Mount
A
3
Installing the mounting bracket
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light fixture.
NOTE: Four mounting bracket screws of various sizes are
included. The installation will only require two. Discard the
unused mounting bracket screws after installation.
□
Remove the existing light fixture.
□
Install the mounting bracket (FF) with the
stamped word "FRONT" facing away from
the junction box. Use the mounting bracket
screws (BB or CC) that best fit the junction
D
box. If necessary, use the screws that were
removed from the existing light fixture.
□
Firmly pull on the mounting bracket (FF) to
verify it is securely mounted to the junction
box.
T
O N
F R
5
Please contact 1-866-308-3976 for further assistance.
Eave Mount
FF
T
O N
F R
BB or CC
HOMEDEPOT.COM
Capítulos
Tabla de contenido
