Care And Cleaning; Troubleshooting - Defiant DFI-5852-BK Guía De Uso Y Cuidado

Care and Cleaning

□
To prolong the original appearance, clean the light fixture with clear water and a soft, damp cloth only.
□
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature
deterioration of the finish. This is not a defect in the finish and will not be covered by the warranty.
□
Do not spray the light fixture with a hose or power washer.

Troubleshooting

Problem
The light will not come on.
The light comes on during the
day.
The light comes on for no
apparent reason.
Possible Cause
□
The light switch is turned off.
□
The fuse is blown or the circuit breaker
is turned off.
□
The light fixture is not properly
attached to the mounting plate, if this is
a new installation (the pins are not fully
seated in the terminal block).
□
Daylight turn-off (photocell) is in effect.
□
The circuit wiring is incorrect (if this is
a new installation).
□
The motion sensor is aimed in the
wrong direction.
□
The outside air temperature is close to
the same as a person's body heat.
□
The motion sensor may be installed in a
relatively dark location.
□
The "Test / Timer" control is in the
"Test" position.
□
The motion sensor may be sensing
small animals, automobile traffic, or
other heat sources.
□
The "SENS" control is set too high.
□
The outside temperature is much
warmer or cooler than a person's body
heat (summer or winter).
□
The light fixture is wired through a
dimmer or timer.
10
Solution
□
Turn the light switch on.
□
Replace the fuse or turn the
circuit breaker on.
□
Re-install the light fixture
to the base and ensure the
pins are fully seated in the
terminal block.
□
Recheck after dark.
□
Verify the wiring is correct.
□
Re-aim the motion sensor
to cover the desired area.
□
Increase the "SENS"
setting.
□
The light fixture is operating
normally under these
circumstances.
□
Set the "Test / Timer"
control to a timed setting.
□
Decrease the "SENS"
setting or reposition the
motion sensor.
□
Decrease the "SENS"
setting.
□
Decrease the "SENS"
setting.
□
Do not use a dimmer or
timer to control the light
fixture. Replace the dimmer
or timer with a standard on/
off wall switch.