Reinstalling The Right (Refrigerator) Door; Reinstalling The Left (Freezer) Door - LG LSXS22423 Serie Manual Del Usuario

2. Use a fl at blade screwdriver to pry back the
hooks (not shown) of the hinge cover (2)
from the top of the refrigerator cabinet. Lift
up the cover.
3. Disconnect all the wire harnesses (3).
4. Remove the grounding screw (4).
5. Rotate the hinge lever (5)
counterclockwise. Lift the upper hinge (6)
free of the hinge lever latch (7).
NOTE: Regardless of hinge lever type, removal
process is the same.
CAUTION
When lifting the hinge free of the latch, be
careful that the door does not fall forward.
5. Lift the door from the lower hinge pin, being
careful to pull the water lines through the
lower hinge pin.
6. Place the door, inside facing up, on a
non-scratching surface. Be careful not to
damage the water feed tube.

Reinstalling the Right (Refrigerator) Door

(1)
(2)
(3)
(4)
Type 1
1. Place the door onto the lower hinge pin.
2. Fit the upper hinge (4) over the hinge lever
latch (5) and into place. Rotate the lever (3)
counterclockwise to secure the hinge.
NOTE: Regardless of hinge lever type, reinstallation
process is the same.
3. Hook the tab on the switch side of the cover
under the edge of the wire opening in
the cabinet top. Position the cover (2) and
replace the screw (1).
(3)
Rivet
(5)
(4)
(5)
Type 2

Reinstalling the Left (Freezer) Door

(2)
(1)
(3)
(4)
(5)
(6)
(7)
Type 1
1. Feed the water tubes through the lower
hinge pin and place the door onto the
lower hinge pin. Water hoses should be
behind the leg to prevent damage.
2. Fit the top hinge (6) over hinge lever latch
(7)and into place. Rotate the lever (5)
clockwise to secure the hinge.
NOTE: Regardless of hinge lever type, removal
process is the same.
3. Install the grounding screw (4) and connect
all the wire harnesses (3).
4. Hook the tab on the door switch side of
the cover (2) under the edge of the wire
opening in the cabinet top. Position the
cover into place. Insert and tighten the
cover screw (1).
5. Reconnect the water tubes by inserting
the tubes into the connectors. The tube is
inserted correctly when only one guide line
is showing out of two.
Collet
Tube
Insert Line
NOTE: When replacing the door, make sure to
connect the water tubes so the colors
match.
INSTALLATION 13
(7)
(5)
(6)
Rivet
Type 2