The travel cot
· The travel cot is used to carry a baby
(from birth up to 15 kg / 33 lbs) in a
horizontal position.
· The travel cot can also be removed
from the stroller so that the baby can
be placed elsewhere while remaining in
the cot.
Fitting the travel cot
· Remove the cover caps from the cen-
tral attachment points by pressing on
the lip (below the attachment point and
then sliding the cap upwards at an an-
gle. (H)
! Keep the cover caps safe, you will need
them again later.
· Slide the adapters over the attachment
points until they click into place. (I)
! Attach the adapter marked R on the right
and the adapter marked L on the left.
· Locate the travel cot on the adap-ters
you have fitted, using the fitting points
on the underside of the cot; press the
cot onto the adaptors until it clicks into
place. (J)
! Position the travel cot so that the foot
end faces the handle grip.
removing the travel cot
· Press in the two buttons (next to the
hood hinge points) so that the travel
cot comes free of its attachments.
The travel cot can now be removed
from the frame. (K)
· The hood can be raised to allow the
travel cot to be carried by hand.
· A carrying handle is built into the hood.
removing the adapters.
· Remove the adapters from the central
attachment points by pressing in the
lip (below the attachment point) and
then sliding the adapter upwards at an
angle. (L)
! Replace the central attachment point
cover caps. (M)
hood
· The travel cot hood is not removable
and has a built-in carrying handle.
· The hood can be moved down when
the buttons to the outside of the hinge
points are pressed in.
stroller insert
Fitting
· The stroller insert is fitted by s liding
the 4 hooks into the plastic b ridging
pieces fitted to the frame, and attach-
ing the 4 poppers and two clips on
the seat to the frame. Two of these
poppers and the two clips must be at-
tached under the foot support. (N)
adjustable back support
· The back support can be lowered or
raised using the strap to the rear of
the support. The back s upport can be
placed steplessly in the desired posi-
tion (O) by pressing in the two lips on
the plastic section and then adjusting
the length of the strap. (P)
adjusting the foot rest
· To adjust the foot rest, move both plastic
handles (L+R) under the foot rest to-
wards you while simultaneously moving
the foot rest into the desired position. (Q)
hood
Fitting and removal
· Slide the plastic hood fixings over the
frame sections provided for this pur-
pose. (R)
· Slide the fixings back on the frame to
remove the hood.
Opening and closing
· To open the hood, press the front of the
English
13