Introduction; Unpacking; Monitor; Power - Philips LTC 2810/90 Instrucciones De Uso

1

INTRODUCTION

1.1

Unpacking

Check for the following items:
• verify the model number
• power cord
• Installation Instructions
1.2

Monitor

The LTC 2810/90 is a multi-standard color monitor housed in
a metal cabinet for rugged reliability. It has a 10-inch tube
(viewable picture area 23 cm (9")). The monitor offers simple
adjustments to meet particular requirements, with default
parameters set at the factory.
With a built-in loudspeaker and inputs able to accept NSTC
and PAL standards, the monitor offers a flexible solution for a
wide variety of surveillance application.
1.3

Power

Model No. Rated
Voltage
LTC 2810/90 100/240 VAC,
50/60 Hz
The monitor is delivered with a 2-pole Euro cord and a 3-pole
US cord.
2

CONTROLS AND FEATURES

2.1

Front Panel

1
Power switch [POWER
Press this switch to turn the power ON or OFF.
2
Video button [VIDEO
Selects the composite video signal inputs to the VIDEO A
(Green LED indication) and VIDEO B (Orange LED
indication) terminal and the audio signal input to the
Voltage Power at Sync
range (VAC) Rated V. Format
90 to 260 50 W NTSC/PAL
]
]
AUDIO A and AUDIO B terminals (RCA connector) on
the rear panel. When selected, the respective indicator
lights.
3
Volume buttons [VOLUME
These buttons have two functions:
Volume control: Press the + or - buttons as required to
adjust the speaker volume.
Data controls: When the SHARP, TINT, COLOR,
BRIGHTNESS and CONTRAST buttons are pressed,
used to change the value of the selected function.
4
Contrast button [CONTRAST
Press this button to adjust picture contrast. Adjust the value
with the VOLUME buttons to control the image contrast
(Default is 60).
5
Brightness button [BRIGHTNESS
Press this button to adjust picture brightness. Adjust the
value with the VOLUME buttons to control the image
brightness (Default is 50).
6
Color button [COLOR
Press this button to adjust the picture color intensity.
Adjust the value with the VOLUME buttons to control the
image color (Default is 50).
7
Tint button [TINT
Press this button to control the picture color to be close to
nateral color. Adjust the value with the VOLUME buttons
to control the color tint (Default is 50).
8
Sharp button [SHARP
Press this button to adjust the picture image. Adjust the
value using the VOLUME buttons to control the sharpness
of the image (Default is 50).
Front panel
1.3
]
]
]
]
] (NTSC only)
]