General Maintenance - GreenWorks Tools G24ST Manual De Utilización

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SV HR HU RO BG EL AR TR HE LT LV ET
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
To avoid serious personal injury, always remove the
battery pack from the tool when cleaning or performing
any maintenance.

GENERAL MAINTENANCE

Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts are
replaced.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
Only the parts shown on the parts list are intended to
be repaired or replaced by the customer. All other parts
should be replaced at an Authorised Service Centre.
English (original instructions)
WARNING
WARNING
WARNING
SPOOL REPLACEMENT See Figure 12.
Use original manufacturer's replacement cutting line for
best performance.
„ Remove the battery pack.
„ Push in tabs (C) on side of spool cover (A).
„ Pull spool cover up to remove.
„ Remove the old spool.
„ To install the new spool (B), make sure the cutting line
is captured in the slot on the new spool (F). Make sure
the end of the cutting line is extended approximately
15cm beyond the slot.
„ Install the new spool so that the cutting line and slot
align with the eyelet (E) in the cutting head (G). Thread
the cutting line into the eyelet.
„ Pull the cutting line extending from the cutting head so
the cutting line releases from the slot in the spool.
„ Reinstall the spool cover by depressing tabs into slots
(D) and pushing down until spool cover clicks into
place.
CUTTING LINE REPLACEMENT See Figure 13.
„ Remove the battery pack.
„ Remove the spool from the cutting head.
NOTE: Remove any old cutting line remaining on the
spool.
„ Cut a piece of cutting line approximately 3m long.
„ Insert the cutting line into the anchor hole (B) in the
upper part of the spool. Wind the cutting line around
the upper part of the spool clockwise, as shown by the
arrows on the spool. Place cutting line in the slot (C)
on upper spool flange, leaving about 15 cm. extended
beyond the slot. Do not overfill. After winding the cutting
line, there should be at least 0.635 cm between the
wound cutting line and the outside edge of the spool.
„ Replace the spool (A), and the spool cover. Refer to
spool replacement earlier in this manual.
4