All Models - Vollrath Cayenne 2000 Manual Del Operador

CLEANING
WARNING
Electrical Shock Hazard
Keep water and other liquids from entering the inside of the
equipment. Liquid inside the equipment could cause an
electrical shock. Do not spray water or cleaning products.
Liquid could contact the electrical components and cause a
short circuit or an electrical shock.
CAUTION
Burn Hazard
Allow equipment to cool before moving or cleaning.
NOTICE: Do not use caustic cleaning chemicals, steel wool or
commercial lime removal products to clean the equipment.
Thoroughly rinse equipment with water after cleaning.
NOTICE: Do not immerse the cord, plug or equipment in water or
any other liquid.
TROUBLESHOOTING
Problem
Warmer does not heat
The warmer does not get hot enough Too much water in the well.
®
Cayenne Model 2000 and 2001 Warmers Operator's Manual
Might be Caused By
Heating element malfunction.
Thermostat control malfunction.
To maintain the appearance and increase the service life, clean your
equipment daily.

All Models

1. Turn the ON/OFF and heat control knob to the OFF position and
unplug the unit. When removing hot food containers from unit use
gloves, mitts or pot holders to protect hands.
2. Carefully empty water from the well.
3. Allow the equipment to cool completely before cleaning.
4. Use a damp cloth or sponge dipped in soapy water.
72557 / 72652
1. Follow the instructions for All Models.
Clean and sanitize the drain valve
1. Unscrew the large nut on the drain valve and remove the drain valve
assembly.
2. Unscrew the bonnet on top of the drain valve assembly from the
lower portion. Pull the seat cup to remove it from the stem and
inspect it or wear or damage. Replace components if necessary.
3. Clean all parts, including the drain valve body, in hot soapy water;
sanitize with chlorine (50 ppm), iodine (14 ppm) or quaternary
ammonium compound (100 ppm); rinse thoroughly with clear, hot
water.
4. Snap the seat cup over the stem by applying direct pressure, and
screw upper assembly back into body. Hand tighten only to prevent
damage.
5. Install drain valve back onto end of water tube with large nut.
Course of Action
Replace heating element.
Replace thermostat control.
Reduce water amount to the correct level.
3