Parallel Connection - Amate Audio X210 Manual De Usuario

X210/X215W/X218W3K/X21T
IMPORTANT: If the user wants to adjust its own cardioid preset there is a
specific manual to do it. Please, contact the sales department of Amate Audio
for more information.
7. CONNECTING

7.1. Parallel connection

Connect the signal (mixing desk output) to INPUT on the first unit. Use the LINK
output to transfer the INPUT signal to the second unit and thus sequentially for
further units. All of the units in this chain must be switched on.
For the mains connection in parallel use the cable with grey Neutrik PowerCon
NAC3FCB at one end and the blue Neutrik PowerCon NAC3FCA at the other end.
Do not connect more than four X210A units using the AC Stacking
output connector (this is the maximum number of units that can be
linked). Nevertheless, we recommend to link two units whenever is
possible.
Do not connect Xcellence Line Array series units in parallel using PowerCon-
PowerCon without earth.
Fig.29. Parallel connection for the Xcellence Line Array series (signal and mains)
7.2. Parallel connection with subwoofers
You can connect X215W, X218W3K and X21T subwoofers in parallel with X210
cabinets. Please, follow the same parameters as explained in figure 29.
38
Oct 2017
Amate Audio