Amate Audio X210 Manual De Usuario página 31

X210/X215W/X218W3K/X21T
CARDIOID
(Cardioid
polar pattern, with
processing,delay
and inverse
polarity)
Fig.18. X21T PRESET options
5.3. Control and connection panel
The X21T control panel contains the following elements:
A) LCD: Displays basic information about the DSP Status
B) KEYPAD: Allows the user to perform basic operations on the DSP such as IP
address setting, Preset selection, etc.
C) STATUS LEDS: Report a special event happening in the system
 Protect: (Red) A fault condition is being reported by the amplifier. If this LED is
constantly lit even after resetting the device, please contact the technical
service.
 Standby: (Orange) This led is lit when the equipment is set in Low Power
Consumption mode. This mode can only be set through the PC connection.
 Mute: (Orange) The system is muted (amplifiers are disabled). The system
can be muted from the PC remote control or from the keypad.
IMPORTANT: When the amplifier is in MUTE, the PROTECT LED will be also lit to
show that the amplifier is disabled. Also when the system is waking up from the
STANDBY mode, the PROTECT led will be lit for a few seconds. Under these
circumstances the PROTECT LED is reporting that the amplifier is disabled, but not a
fault condition.
D) SIGNAL INPUT LEDS: Monitor the signal arriving at the module input.
 Input: Signal is present at the input. Nominal input level is +2dBu (1Vrms).
 >8V Overload: The input signal exceeds +14dBu (4Vrms), so it will be
compressed. Avoid the continuous lighting of this led in order to preserve the
dynamic range of the audio signal.
E) OUTPUT LEDS: Show the amplifier output level
 -24dB: The amplifier is delivering output power at -24dB of its maximum
power
 -12dB: The amplifier is delivering output power at -12dB of its maximum
power
 Clip: The amplifier is delivering its maximum output power
The connection panel has the following parts:
31
Oct 2017
Amate Audio