Troubleshooting - Pulsar HD6580B Manual Del Usuario

Problem
Engine is running, but AC output is not
available
Engine runs well without load but bogs
down when loads are connected
Engine will not start, shuts down during
operation, or starts and runs rough.
Engine lacks power
Engine "hunts" or falters

TROUBLESHOOTING

Cause
1. Open circuit breaker
2. Poor connection
3. Defective cord set
4. Connected device is faulty
5. Fault in generator
1. Short circuit in connected device
2. Generator is overloaded
3. Clogged fuel filter
4. Engine speed is too slow
5. Short circuit in generator
1. ON/OFF switch set to "OFF"
2. Dirty Air filter
3. Clogged fuel filter
4. Stale fuel
5. Spark plug wire disconnected from
spark plug
6. Bad spark plug
7. Water in fuel
8. Fuel valve is in "OFF" position
9. Over choking
10. Low oil level
11. Rich fuel mixture
12. Intake valve stuck open or closed
13. Loss of engine compression
14. Dead battery
15. Engine has flooded
1. Generator is overloaded
2. Clogged fuel filter
3. Dirty Air filter
4. Engine needs servicing
1. Choke was removed too soon
2. Clogged fuel filter
3. Carburetor is running too rich or too
lean
22
Solution
1. Reset circuit breaker
2. Check and repair
3. Check and repair
4. Connect a device that is working
properly
5. Contact service department
1. Disconnect device
2. See pg 15 "Don't overload
generator"
3. Clean or replace fuel filter
4. Contact service department
5. Contact service department
1. Turn switch to "ON"
2. Replace Air filter
3. Clean or replace fuel filter
4. Replace fuel
5. Reconnect spark plug wire
6. Replace spark plug
7. Drain fuel tank and replace fuel
8. Turn fuel valve to "ON" position
9. Turn off choke
10. Fill crankcase to proper oil level &
place generator on a level surface
11. Contact service department
12. Contact service department
13. Contact service department
14. Recharge or replace battery
15. Wait 5 minutes and recrank engine
1. See pg 15 "Don't overload generator"
2. Clean or replace fuel filter
3. Replace Air filter
4. Contact service department
1. Move choke to middle position until
engine runs evenly
2. Clean or replace fuel filter
3. Contact service department