Johnson Controls York AS1 Instrucciones De Instalación página 7

Thermostat wiring
����������
����������������������
AS1 probe connections
�
�
�
�
�
1. Connection terminals to the DPC thermostat or another
AS1 probe.
2. Probe selection: S5, S6, S7 or S8.
3. Operating Led.
4. NTC probe.
������������ ��������������
��
����������������������
������
���������������
�� ��������������
�� � � �� � � �� � �
��� ���
���������������������
�� ��
����������
� � � �
�� ��
�
�� ��
��
� � �� � � ��
���
���
���
���
5. Connection of duct remote probe DS1. Optional.
6. Remove jumper JP1 to select the duct probe. Optional.
���
�����
�� � �
��� ���
�� ��
� � � �
�� ��
GB
Programming temperature rea-
dout origin
The AS1 remote probe must be configured
on the DPC thermostat as S5, S6, S7 or
S8.
To configure the origin of the probe, go to
the main screen that indicates the ambient
temperature and the time.
- Press the key.
����
- Press keys simultaneously.
- Press the key. Submenu P2 should
����
appear on the hour side.
- Press the key to select the origin of
the probe as S5, S6, S7 or S8.
- Press the key to validate.
- Press the key to go back to the main
screen.
Programming temperature rea-
dout calibration
Readout of the AS1 remote probe must
be calibrated on the DPC thermostat once
installed.
To configure temperature readout, go to
the main screen that indicates the ambient
temperature and the time.
- Press the key.
����
- Press keys simultaneously.
- Submenu P1:S1 should appear on the
hour side.
- Press the key to select P1: S5, S6, S7
or S8.
- Press the and
calibration, up to a maximum of 3°C posi-
tive or negative.
- Press the key to validate.
- Press the key to go back to the main
screen.
15 minutes later, recheck the remote probe
readout with a calibrated thermostat and, if
necessary, adjust probe calibration.
Selection of digital outdoor probe
A digital remote probe can be installed on
the DPC thermostat and be configured as
an outdoor probe. Set both SW1 micros-
witches to ON and, on the DPC thermostat
monitoring menu, select the outdoor digital
probe option. In this case, the maximum
number of outdoor digital remote probes
will be three.
DS1 duct remote probe option
The digital remote probe allows the pos-
sibility of connecting a duct remote probe
at connector J4. Remove jumper JP1 to
read the value of the duct probe. To avoid
any trouble reading the duct temperature,
it is recommended to select continuous fan
operating mode during operation.
keys to modify
7