Product Maintenance - Fellowes Powershred 125Ci Guía De Inicio Rápida

PRODUCT MAINTENANCE

CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run
even if there is no paper present
TO CLEAN THE SENSORS
1
2
AUTO
Locate Auto-start
shredder infrared sensor
OILING SHREDDER
empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
Press and hold forward
*Apply oil across entry
( ) 2-3 seconds
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
will remain illuminated and the shredder will not operate for the duration of the recovery time.
Remove Paper: When illuminated, press reverse (
SafeSense ® Indicator: If hands are too close to the paper entry, the SafeSense
is active for 3 seconds, the shredder will automatically turn off and the user must press the power button on the control panel to resume shredding.
Self Cleaning Cycle: Shredder periodically cycles in forward and reverse lasting 3-6 seconds (125Ci only).
4
.
3
Dip cotton swab in
rubbing alcohol
AUTO
4
away any contamination
from the paper sensors
® indicator will illuminate and the shredder will stop shredding. If SafeSense
ENGLISH
Models 125Ci/125i
®