Specifications And Limitations Aqu36 - Aquanex AQU36 Manual Del Propietário

SPECIFICATIONS AND LIMITATIONS AQU36

Total Grain Capacity: AQU36
Maximum Ferrous Iron ("clearwater iron" only)**
Maximum flow rate to drain during
Water Pressure Drop at 11 GPM
Media Tank With Valve: AQU36
Salt/Potassium Storage Capacity
(salt recommended: 99.99% pure pellets
Approximate Shipping Weight (with no salt)
*Efficiency based on factory set HE salt setting
**Iron can be in several forms, pretreatment will
be necessary if certain types of iron are
encountered. Iron removal is not based on certi-
fied WQA Test Data.
***Continuous means to a 110 outlet that has
continuous voltage not able to be turned off by
a light switch. GFI outlet recommended.
Tested and Certified by WQA against NSF/ANSI Standard 44
for softener performance & 372 for "Lead Free" compliance.
5 • 1/12
Efficiency*
Maximum Water Hardness
Minimum pH
Regeneration Time
regeneration: AQU36
Water Pressure
Service Flow Rates: AQU36
Temperature
Bypass Valve Size
Drain Line Size
Electrical Requirements***
System Dimensions:
for maximum performance)
36,089 @ HC Setting @ 17.5 lb of salt
29,481 @ Sd Setting @ 11.3 lb of salt
15,821 @ HE Setting @ 3.6 lb of salt
4400
99 Grains Per Gallon
1-10 PPM
7
Approximately 60 – 90 Minutes
2.7 GPM
20 Min. –125 Max. PSI
11 GPM
15 PSIG
: 34° to 120° F •
air
1"
½"
(under 20' run and lower than 10' vertical at 60 PSI)
¾"
(over 20' run or over 10' high, or over 7 GPM
backwash rates)
Continuous 110 Volt, 60 Cycles
10" dia. × 42" high
Foot Print 13" x 19" x 43"
150 lbs.
100 lbs.
: 35° to 100°F
water