Aquanex AQU36 Manual Del Propietário página 38

STEP 2 SET SALT SETTING
The controller starts (defaults) with the HE
(high efficiency) setting. If you want to check
or change the setting, press the Salt Amount
button to display the current setting. To change
it, press the Salt Amount button again within 5
seconds. The new setting will be saved after 5
seconds.
HC: This setting maximizes the system capacity
between recharges and will also use the most
salt. This setting can be used if you have high
water hardness or high water usage. Example: 3
or more people and/or hardness above 25 gpg.
Sd: This setting will provide a mid-range
capacity. Less salt is used than the HC (High
Capacity), setting. More water between
recharges is provided than when the HE (High
Efficiency) setting is used. Use this setting if the
conditioner is running out of capacity when set
to HE. This setting is also used if the HC setting
is providing too much capacity. Use this setting
if your usage or water hardness fall between the
HC and HE examples.
STEP 3 SET HARDNESS OF WATER
The controller starts (defaults) at a hardness of
25 grains per gallon. Check your water for the
actual hardness. Press the Water Hardness
button to display the current settings. To change
the setting press the button again within 5
seconds. To rapidly increase the setting push
and hold the Water Hardness button. Release
the button and the setting will be saved after 5
seconds. A hardness setting too high will cause
the system to recharge more often and use more
salt and water than what is needed to soften
PROGRAMMING IS COMPLETE
The controller will begin normal operation if
no button is pushed for 5 seconds.
During normal operation (Service mode) the
display will show the current time of day with the
colon blinking. This will alternate with a display
of the gallons remaining to be treated before
recharge.
37 • 1/12
HE: This setting minimizes salt used for a
recharge (uses the least amount of salt) and
provides the least amount of water between
recharges. This setting can be used if you
have low water hardness or low water usage.
Example: 2 or less people and/or hardness
below 20 grains per gallon.
Figure 22 Step 2
Figura 22 Paso 2
your water. A hardness setting too low will cause
the system to recharge less often. The system
may pass hard water shortly before it recharges.
Figure 23 Step 3
Figura 23 Paso 3