How To Operate - Zyris ISODRY Instrucciones De Uso

Installation
Isodry is designed to install easily in most
dental operatories (Figure 1). Installation
and usage instructions, including a video
demonstration, are available at Zyris.com.
Connect the Vacuum Hose to the
Step 1
vacuum canister by fitting the end of the
Vacuum Hose onto an auxillary HVE port
on the vacuum canister. If an auxillary HVE
port is not available, use the provided
Y-adapter, so that the standard HVE hose
may remain connected.
Control
Head
Figure 1. Installation
6
Vac Canister
HVE Port 1
HVE Port 2
Vac Canister
Standard
HVE
Hose
Vacuum Hose
NOTE: For countries outside the USA, installation
may need to be completed by a qualified service
technician. Please consult your in-country
representative for additional information.
Connect the Control Head to
Step 2
the head of the Vacuum Hose. Once
connected, test the dual Vacuum Levers
to confirm suction functionality.
Place the Isodry in an open slot on
Step 3
the toolbar when not in use.

How to Operate

Using the Dual Vacuum Levers
Dual Vacuum Levers adjust suction
intensity in both the upper and lower
quadrants. To adjust, rotate the Left and
Right Vacuum Levers to the desired
suction intensity for each quadrant.
To shut off suction, rotate the Levers to
Hose
the most downward position.
Selecting the Mouthpiece
To select the correct Mouthpiece
size, measure the patient's interincisal
opening. If between sizes, you may select
the smaller size.