Tabla de contenido
Idiomas disponibles
Idiomas disponibles
RISk OF UNSAFE OPERATION . For your own safety, do not connect the machine to the power source
until the machine is completely assembled and you read and understand the entire instruction manual.
1. If you plan to use your drill press in a permanent
location, you must secure the drill press base to the
supporting surface with fasteners through the two
mounting holes (A) Fig. 3 in the drill press base.
RISk OF UNSAFE OPERATION . If you
do not fasten your drill press in a permanent manner,
you must fasten the drill press to a plywood mounting
board to prevent the drill press from tipping over
during normal use .
RISk OF UNSAFE OPERATION . Use
a good grade of plywood with a minimum 3/4"
thickness . do not make the mounting board from
particle board since particle board breaks easily .
2. Use a plywood board base with the minimum
dimensions as shown in Fig. 4 for mounting the drill
press base to a supporting surface.
3. Place the drill press base (D) Fig. 5 centered on the
supporting surface (E).
RISk OF UNSAFE OPERATION . Make
sure that the plywood extends a minimum of 3" on all
four sides of the base as shown in Fig . 5 .
4. Drill two 3/8" diameter holes through the holes (A)
Fig. 3 in the drill press base, and in the supporting
surface (E) Fig. 5.
NOTE: Place a piece of scrap wood underneath the
supporting surface when drilling the through holes so
that the drill bit will not damage the material beneath
the supporting surface.
5. Fasten the drill press base to the mounting board
using the carriage bolts, flat washers, lockwashers,
and hex nuts (C) Fig. 4 furnished with your drill
press. Countersink the holes for the carriage bolt
heads and flat washers under the board so that
the bolt heads are flush with or below the bottom
surface of the board. Use a flat washer, lock washer,
and hex nut above the drill press base as shown at
(F) Fig. 5.
ASSEMBLY
ASSEMBLY TOOLS REQUIREd
3mm and 5mm hex wrench (supplied)
10mm, 17mm, 24mm open end or socket wrenches (not supplied)
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes approximately 30 minutes to 1 hour.
3" MINIMUM
3" MINIMUM
10
A
Fig . 3
Fig . 4
3" MINIMUM
F
d
3" MINIMUM
E
C
Fig . 5
Tabla de contenido
