Fahrenheit Or Celsius; Vent Control; Air Direction - GE AKL08 Manual Del Propietario E Instrucciones De Instalación

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

When the air conditioner is turned on, it will

automatically start in the setting last used,

except the timer will be cancelled if it was set.

COOL Mode

Use the COOL mode with HIGH, MED or LOW fan

for cooling. Use the Increase v / Decrease w pads

to set the desired temperature between 60°F and

90°F in 2°F increments (or between 16°C and

31°C in 1°C increments if the control has been

set to use Celsius).

A thermostat is used to maintain the room

temperature. The compressor will cycle on and off

to keep the room at the set level of comfort. Set the

thermostat at a lower number and the indoor air

will become cooler. Set the thermostat at a higher

number and the indoor air will become warmer.

NOTE: If the air conditioner is off and is then turned on while

set to COOL, it will take approximately 3 minutes for the

compressor to start and cooling to begin.

FAN Mode

Use the FAN at HIGH, MED or LOW to provide

air circulation and filtering without cooling.

Since fan only settings do not provide cooling,

a temperature setting will not be displayed.

Vent Control

The vent control is located on the inside of the

air louvers at the bottom of the vent.

When set at CLOSE, only the air inside the room

will be circulated and conditioned. When set at

OPEN, some inside air is exhausted outside.

Air Direction

Up and Down

Fingertip pressure on the horizontal louvers

adjusts the air direction up or down.

Lights in the display or beside the touch pads

on the air conditioner control panel indicate the

selected settings.

Cooling Descriptions

For Normal Cooling—Select the COOL mode and

HIGH or MED fan with a middle set temperature.

For Maximum Cooling—Select the COOL mode

and HIGH fan with a lower set temperature.

For Quieter & Nighttime Cooling—Select the

COOL mode and LOW fan with a middle set

temperature.

NOTE: If you switch from a COOL setting to OFF or to

a fan setting, wait at least 3 minutes before switching back

to a COOL setting.