Operating Controls; Installation Instructions - Motorline professional SP SHUTTLE 60/100 Manual De Usuario

Operating Controls

Fig. 01
01 - (K1 button) Increase
02 - (K2 button) Decrease
03 - (K3 button) Confirm set and Options menu
04 - (K4 button) Transmitter code set
05 - LED display
Circuit Board Connectors
Fig. 02
06 - Connector for backup battery
07 - Connector for motor
08 - Connector for power transformer
09 - Terminal for connection of the power input, run lamp and transformer
10 - Terminal connector for Digital Board
11 - Terminal for connection of photocells or push button

Installation Instructions

Sectional overhead door (max height 2300mm)
01 - Read the instructions carefully;
02 - Make sure the door structure is solid and suitable to be motor driven;
03 - Make sure that when the door is moving there are no friction points;
04 - The door must be balanced;
05 - Install a 230V, adequately protected with ground socket near where the MOTORLINE opener is going to be installed.
Fig. 03
1 - MOTORLINE opener;
2 - START wall switch;
3 - Key selector switch or digital keypad;
4 - Photocells;
5 - 230V 15W max lamp.
Installation Instructions
Use both motor brackets (E) (Fig. 04) to fix the rail to the motor. Fix these brackets to the motor (E) (Fig. 04) with 6mm screw nuts (D) (Fig. 04).
Fix the bracket (F) (Fig. 04) where the rail needs to be fixed to the ceiling.
Installation Instructions
Remember there are specific standards that have to be strictly followed regarding the safety of automatic gates and doors' electrical
installations.
As well as the legal requirements and standards that must be adhered to, please take note of the following points to ensure maximum safety
and reliability of your installation:
01 - Prior to installing check the surrounding environment. Carefully evaluate any hazards there could be from physical damage (transiting
vehicles, parts of trees falling, etc.), possible contact with strange bodies (insects, leaves, etc.), flooding hazards or any other exceptional events;
02 - Check if the main power supply voltage is the same one as requested in this manual;
03 - Check there is suitable electrical protection against short circuits/power spikes and proper ground on the main power supply. Remember
the unit has mains voltage running through it (electrocution hazard, fire hazards);
04 - Take care with the control unit: parts may be subject to damage if abused;
05 - Make sure you have all the necessary materials and that they are suitable for this kind of use;
06 - Read all the instructions through at least once;
07 - Before starting the installation, carefully analyze all the risks regarding the automatization of the door. Verify that the door to be
automatized is in a good condition and that the mechanisms are in good working order; respect the safety margins and minimum distances;
08 - Evaluate with particular care the safety devices to be installed and where to install them; always install an emergency STOP device for
interruption of power supply to the opener if required;
09 - Once the risks have been analyzed, install the MOTORLINE opener and relative safety devices, emergency STOP and/or photoelectric cell;
10 - When installing the MOTORLINE opener, strictly follow all the instructions given in the instruction manual; if some points are not clear do
not install the unit until all doubts have been cleared up with our technical department.