Special Instructions - Whittier Wood 589Wb Instrucciones Para Armar

589Wb Palmer Wardrobe/Media Center — Parts List
ZC — Spacer — Qty. 1
ZE — #8 x 1¾" Pan
Head Screw — Qty. 4
ZF — #8 x 1" Machine
Screw — Qty. 2
ZG — Tack Glide
— Qty. 2
ZH — #8 x 7/8"
LoProfi le Screw
— Qty. 8
Z I — Furniture Tipping
Restraint — Qty. 1
If a top or panel should become cupped, do not be alarmed. The panel was fl at when it was manufactured.
It is a natural characteristic of wood in an unfi nished state to cup from uneven moisture condi-
tions. The fi gure at the right shows an exaggerated view of what could happen. This only
means that the convex side has absorbed moisture, or the concave side has
dried out.
Usually a cupped panel will equalize and straighten out if both sides are ex-
posed to similar conditions for a day or so.
IMPORTANT:
We recommend fi nishing the unit before fi nal assembly. Before fi nishing, read enclosed fi nishing hints.
NOTE: Due to the fact that more than one type of hardwood is used, we recommend testing for desired color.
To test for desired color on:
a) Veneer parts—apply stain to unexposed portion of side panel. See FIGURE 1A.
b) Alder pieces—apply stain to back of base. See FIGURE 5C.
Page 4 — 589Wb — Rev. 9/07
ZK — Shelf Bracket
— Qty. 4
ZL — #6 x 1/2" Unercut
Screw — Qty. 4
ZM — Clothes Bar
Support — Qty. 1 Set
ZN — Clothes Bar — Qty. 1
Z1 — Shelf Leg —
Qty. 2

SPECIAL INSTRUCTIONS

ZP — #8 x 1" Pan Head
Screw — Qty. 9
ZQ — Door Skirt — Qty. 1
ZR — #8 x 1¼" Machine
Screw — Qty. 4
ZS — Right Angle
Bracket — Qty. 2
ZT — 3 Sided Bracket
— Qty. 2
(cont.)
ZU — #6 x 5/8"
Philtruss Screw —
Qty. 27
ZV — Rafi x Cam —
Qty. 4
ZW — Rafi x Bolt —
Qty. 4
ZX — Knob — Qty. 6