Tabla de contenido
FIG. 11
11) Attach the two Drawer Faces (O) to the Drawers. Insert the #8 x 1¼" Machine Screws (ZR) through
the center holes in the Drawer False Front and LOOSELY fasten the Knob (ZX). See FIGURE 11.
DO NOT INSERT LOPROFILE SCREWS (ZH) AT THIS TIME.
O
ZC
FIG. 12A
12) Install the bottom drawer in the unit. Make sure that the Knobs (ZX) are loose enough to allow the
Drawer Face to move freely on the Drawer False Front. Adjust the bottom Drawer Face (O) on the
Drawer False Front (P) so that it is centered side to side, and using the Spacer (ZC), 1/8" above
the top of the Base (I). See FIGURE 12A. Tighten the Knobs (ZX) to eliminate any shifting of the
Face. Insert four #8 x 7/8" LoProfi le Screws (ZH) through the holes in the Drawer False Front (P)
and fasten securely. See FIGURE 12B.
Repeat the above steps for the other drawer. There should be a 1/8" gap between the drawers to
allow for proper functioning of the drawer slides.
If necessary, adjust the hinges on the doors so that they line up with the drawers. Insert the remain-
ing Screws (Z) in the round holes in the hinges at this time.
O
ZX
I
ZX
ZX
ZR
P
ZH
O
FIG. 12B
Rev. 9/07 — 589Wb — Page 11
ZH
Tabla de contenido
