Mounting Options - e-conolight ECONOLED Instrucciones De Instalación

Install 4-way Power Splitter (optional)
Match the icons on each Power Supply (PS) Link Connector with the icons in the 4-way Power Splitter.
Repeat the same connection method with the Power Supply and the 4-way Power Splitter.
Install Connectors (optional)
(A) With the LED side facing up, slide one LED Cable strip into the opening in one side of the connector until it reaches the end.
Repeat with the other LED Cable strips in the other sides of the connector if required. Make sure to match polarity.
(B) Push the LED Cable strip completely into the connector. The ridges on each side of the LED Cable strip will be covered when the strip is properly installed.
(C) Using pliers, apply even pressure to the bottom and top halves of the connector to push the connector together. This secures the LED Cable strip inside.
Install End Cap
At the end of your LED Cable run, slide the End Cap onto the end of the strip that
will not have a connector. The End Cap protects the LED Cable strip.
Look for the ridges
on each side of the
LED Cable strip.
w w w . e - c o n o l i g h t . c o m | s a l e s @ e - c o n o l i g h t . c o m | 8 8 8 . 2 4 3 . 9 4 4 5
IMPORTANT
!
Only use connectors once. Once LED Cable is inserted into
connector, removing LED Cable will damage the cable and connector.
Slide LED cable until
all of the ridges are
covered.

Mounting Options

Channel Bracket
Edge Bracket
Channeling
IMPORTANT
!
M2.9 (#4) screws are recommended, provided by others.
Installation Instructions
Installs with one screw (by others).
Barely visible after LED Cable
snaps in.
Installs with one screw (by others).
Use for flush mount installations
such as along a baseboard.
Installs with screws (by others). LED
Cable snaps securely into place.