Turn On And Test Installation - Neumann MINIMISSION Guia De Instalacion

4. Turn on and test installation

This is the exciting part where you can turn your Minimission
Open the panel cover, press
power button,
then input the default PIN
Press the key and close
the control panel cover:
Your Minimission
find its way to the charging
14
Watch the Minimission
EN
it returns to the charging
base and modify the
positioning of the boundary
wire if necessary. When the
Minimission successfully
®
returns to the charging base,
this means the installation
has been successfully
completed! Now your
Minimission will start to fully
®
If your Minimission
outside its territory, it
will not move and the
display will indicate
"outside working
area" error. Just move
it inside its territory
and repeat step 4.2
NOTE: Please refer to the Programming and Troubleshooting Guide for more information
4.2
0000.
will now
®
base.
as
®
charge.
is If your Minimission
®
is inside its territory
but the display says
"outside working area"
and the LED is on, it
means you clamped
the boundary wire
ends incorrectly. Just
reverse them.
on for the first time.
®
4.1
Place your Minimission
few meters from the back of the charging base.
09:00 09:00
Wed. 2012-6-8 Wed. 2012-6-8
Default Default
Your Minimission
®
should always remain
switched on. If you ever
need to turn it off, then
make sure you place it
within its boundary area
before you switching it
back on again.
inside the working area, a
®
09:00 09:00
Wed. 2012-6-8 Wed. 2012-6-8
Default Default
Should your
®
Minimission stop
®
operating unexpectedly,
just press its ON/OFF
key to ON, correct the
problems, press Start
button and close the
cover.