Turn On And Test Installation - Neumann Mission Guia De Instalacion

4. Turn on and test installation

This is the exciting part where you can turn your Mission
Open the keypad window
by pressing the large red button
on the top of your Mission
Press and hold down the Power
ON/OFF
until the Mission
®
the default PIN 0000
Press the
and close the keypad window:
14
your Mission
EN
find its way to the charging base.
Watch the Mission
to the charging base and modify
the positioning of the boundary
wire if necessary. When the
Mission successfully returns to
®
the charging base, this means the
installation has been successfully
completed! Now your Mission
will start to fully charge.
If your Mission
outside its territory, it
will not move and the
display will indicate
"outside working
area" error. Just move
it inside its territory
and repeat step 4.2
NOTE: Please refer to the Programming and Troubleshooting Guide for more information
4.2
.
®
key
turns on. Input
key
will now
®
as it returns
®
®
is If your Mission
®
inside its territory
but the display says
"outside working area"
and the LED is on, it
means you clamped
the boundary wire
ends incorrectly. Just
reverse them.
on for the first time.
®
4.1
Place your Mission
meters from the back of the charging base.
is Your Mission
®
always remain switched
on. If you ever need to
turn it off, then make
sure you place it within
its boundary area
before you switching it
back on again.
inside the working area, a few
®
Should your Mission
should
®
stop operating
unexpectedly, just press
the STOP button, open
its keypad window,
press its ON/OFF key
to ON, correct the
problems, press
button, shut its keypad
window.
®