Recalling Memory; Troubleshooting - Health O Meter 7633 Manual De Instrucciones

Recalling Memory

1. To recall stored blood pressure readings, simply press the "M" button.
The memory values will be shown on the LCD display. Every new press of the
"M" button recalls one set of previously stored values. The most recent
memory readings will be recalled first.
Note:
1. The data in the memory will not be lost even when the Blood Pressure Monitor
is switched off.
2. You can erase the memories stored by one of 2 ways:
• remove the batteries
• press the memory recall key for more than 5 seconds

Troubleshooting

If a problem should arise during use, please check the following points.
Symptom
No display when the
POWER button is pressed
EE mark shown on the display
or the blood pressure value
is displayed excessively low
(or high)
Note: If the unit still does not work, please see the Warranty Information in this manual.
Under no circumstance should you disassemble the unit and attempt repairs yourself.
Check Point
Have the batteries run down?
Have the batteries been
properly positioned in the
compartment?
Is the cuff placed correctly?
Did you talk or move during
the measurement?
Did you shake the arm with the
cuff on it?
14
Correction
Replace them with 2 new
"AAA" alkaline batteries
Re-insert the batteries
in the correct position
Wrap the cuff properly so
that it is positioned correctly
Measure it again quietly