Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TRANSPORTATION
ATTENTION! Full containers have to be closed tightly when transported in the container.
Do not lay the case on its side if it contains full containers of paint.
CLEANING THE PRODUCT
i
In order to ensure smooth operations, the machine has to be cleaned thoroughly every day.
Fig.9
1
3
Divide the spray gun. Press the lock knob and twist it to the unlock point, put the spray attachment out of the main body.
ATTENTION! Never hold the rear part of the spray gun under water or immerse it into liquids. Clean the housing only with
a moistened cloth.
•
Unscrew the container.
Pour the remaining coating material into the container. (Fig. 2 )
•
Pre-clean the container and suction tube using a brush and suitable cleaning agent.
Clean the ventilating bore. (Fig. 9, 3 )
•
Fill the container with a non-flammable water. Screw the container back on.
Do not spray flammable materials for cleaning purpose
ATTENTION! When cleaning devices with flammable solvents, disconnect the device from the mains supply
and clean thoroughly with a brush and cloth. Before starting the device up again, ensure that all traces of solvents
are removed thoroughly. Allow the cleaned parts to dry completely.
Connect spray attachment and main body. (Fig. 2 )
•
•
Pull the trigger to rinse the spray attachment. Repeat the procedure above until the solvent or water emerging from
the nozzle is clear.
•
Turn off the machine and divide the spray gun.
•
Screw off the container and empty it.
Unscrew suction tube with container seal. (Fig. 9)
•
Clean suction tube and suction nozzle in spray attachment with cleaning brush. (Fig. 10)
•
CAUTION! Never clean seals, no-return valve and nozzle or air holes of the spray gun with metal objects. The ventilation
hose and no-return valve are only solvent-resistant to a limited extent. Do not immerse in solvent, only wipe.
Unscrew the union nut (fig. 12, 1 ) from spray attachment, remove the jet width adjusting lever (fig. 12, 2 ) carefully
•
from the union nut. Remove air cap (fig. 12, 3 ) and nozzle (fig. 12, 4 ). Thoroughly clean all parts.
•
Clean the outside of the container with a cloth soaked in solvent or water.
•
Assemble the parts again (see "Assembly").
Fig.2
1
2
Press and
then turn
Fig.3
2
Fig.10
1
A
Tabla de contenido
