IMER SMALL 50 Manual De Uso, Mantenimiento Y Repuestos página 23

11. START-UP (see fig.6)
After positioning the machine, prepare a bucket with a quantity
of approx. 10l. of grout. Pour the grout into the machine
hopper, or, in the case of using colorant products, directly in the
machine pipelines before connection. In the latter case, pour
approx. 10l. of coloured product into the hopper. Check the
material hoses to ensure perfect condition, that couplings are
intact and the relative seals are fitted, then connect them to the
delivery manifold and spray jet. Check that the cam levers ( A )
of the couplings have been tightened correctly and that the seal
(B) is fitted as shown in fig. 6a.
Close the spray jet valve (ref. 15a), turn the main switch (ref. 3)
to 1(ON), switch on the optional compressor if used, and turn
the selector (ref. 7) clockwise to the start position. The pushbut-
tons (+) flow rate (ref. 6) and (-) flow rate (ref. 5), control the
flow rate as shown on the display (ref. 8) at 30. Open the spray
jet air valve (or pneumatic control)(ref. 15d) or start the machi-
ne by means of the electric remote control: the pump starts to
rotate slowly. Depending on the machine configuration, wait
until the grout in the hopper reaches the level of the mixer, or
until the coloured product is delivered from the jet. At this point
shut down the machine by means of the pneumatic or electric
control, fill the hopper and start work as required. Adjust the
quantity of material delivered from the jet as required, by means
of pushbuttons (+) and (-). When the electric remote control is
connected, the selector should be set to the start position. The
machine is controlled exclusively by means of the electric remo-
te control.
The machine is fitted with protection against power failure: if this
occurs, the main switch must be reset to restart the machine (turn
from 0 to 1).
To stop the machine in the event of an emergency, press the red
emergency button (ref. 2) To isolate the machine, all moving parts
are shut down and then turn the main switch to 0 and remove the
electric power plug from the socket (ref.11).
IMER INTERNATIONAL S.p.A.
IMER MORTAR MIXERS
The machine must never be started up or remain in operation if
there is no material in the hopper, to avoid premature wear of the
stator and screw.
23
- Never direct the jet towards yourself or others