miniland baby Thermo talk Manual Instrucciones página 22

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
en
Preparations
1. Replace any low-voltage battery to ensure full power supply.
2. For proper measurement, condition the thermometer for 30 minutes in
measurement site.
3. An unexpected fluctuation of ambient temperature is likely to deteriorate a
measuring accuracy. When a measurement site shows a different
temperature with the area where a thermometer locates, or any attempt to
perform a temperature measure in front of air conditioner, desirable results
are impossible.
4. Be sure to keep ear clean since a ceriman-filled or feather-filled ear is
possible to cause inaccuracy.
5. Measurement shall be done at a rest time to ensure an accurate result.
Temperature is likely to increase immediately after exercise or bathing.
How to take measurement
1. To measure ear temperature:
Pull OUT the FORENHEAD PROBE from the unit, insert the temperature
probe along the eardrum as deep as possible into the ear, then press
measure key once to start the measurement & you will hear a beep sound.
Upon completion you will hear two short beep sound. Now you see it from
the LCD, and you will hear the result via the speaker if the TALK function is
enabled.
2. To measure forehead temperature:
Put ON the FOREHEAD PROBE onto the unit, the gently position the probe
onto the center of the forehead, midway between the eyebrow and the
hairline. Press measure key once to start the measurement &you will hear a
beep sound. Upon completion you will hear two short beep sound. Now
you see it from the LCD, and you will hear the result via the speaker if the
TALK function is enabled.
3. The result will be stored into memory automatically. If 30 sets of memory
are stored already, the first set of data will be removed, and others
decreased by 1 with the new one at the top.
4. Measure 3 times maximum in a consecutive way. It is possible that a proper
body temperature measure is obstructed despite of a normal recovery. For
continuous measurement up to 4 times or above, at least wait for 10
minutes before new measurement.
Tabla de contenido
loading

Tabla de contenido