Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7. Insert the Pin down through the top of the T-Fittings.
8. Carefully slide the Vertical Leg down through the belt t(schema 1) or through sleeves (schema 2) hat runs
around the middle of the pool.
- schéma 1
6
- schéma 2 -
3
3
- 7
- 8 -
9. Insert the vertical leg into the T fitting and rotate until it locks into place (V spring pops out).
10. Go around and check all fittings, legs, and beams are properly installed and secured in place. Make sure
the drain fitting is plugged securely and the cap is in place.
- 9 -
- 10 -
11. Start filling the pool with water until 1-inch of water is on the bottom; then, stop filling and smooth
wrinkles out of the pool bottom. Push outward from inside the pool removing all wrinkles so that it fills
evenly and flat.
- 16 -
Tabla de contenido
