Air Supply - Arrow PT18G Manual De Instrucciones

Description
Arrow's 18GPT Pneumatic Brad Nailer drives 18G brad nails from 5/8" to 2" (15mm to
50mm) in length. The tool has a die cast aluminum body for strong and light weight
design. The tool features a comfortable rubber handle for improved control and comfort
even during extended use and a contact safety to prevent accidental firing and a quick
release nosepiece for fast clearing of jams. The tool is ideal for door and window trims,
decorative trim, and cabinet work, finish paneling, frames, flooring and etc.

Air supply

1. Use clean, Dry and Regulated compressed air at 60-100psi (4-7 bar)
2. Never exceed maximum and minimum pressure. Too low or too high pressure would
cause noise wear and tear or misfiring.
3. When connecting air supply always keep hands and body away from discharge area of
tool.
4. A filter-regulator-lubrication is required and should be located as close to tool as
possible.
5. Keep air filter clean. A dirty filter will reduce the air pressure to the tool causing a
reduction in power and efficiency.
6. For better performance, install a quick connector in your tool and quick coupler on the
hose if possible.
7. Be sure all connections in air supply system are sealed to prevent air loss.
Fig 4.
Tool
OPERATING INSTRUCTIONS
5