Assembly - Powermate Vx SAC22HPP Manual Del Propietario Y De Seguridad

ASSEMBLING THE COMPRESSOR
The air compressor should be turned off, unplugged from the power source, the
air bled from the tank and the unit allowed time to cool before any maintenance
is performed. Personal injuries could occur from moving parts, electrical
sources, compressed air or hot surfaces. The quick connect assembly must
be attached before use. Failure to assemble correctly could result in leaks and
possible injury. If unsure of assembly instructions or you experience difficulty in
the assembly please call your local service department for further information.
1. Unpack the air compressor. Inspect the unit for damage. If the unit has been
damaged in transit, contact the carrier and complete a damage claim. Do
this immediately because there are time limitations to damage claims.
2. Check the compressor's serial label to ensure that you have received the
model ordered, and that it has the required pressure rating for its
intended use.
3. Locate the compressor according to the following guidelines:
a. Position the compressor near a grounded electrical outlet.
b. The compressor must be at least 12 inches (31 cm) from any wall or
obstruction, in a clean, well-ventilated area, to ensure sufficient air flow
and cooling.
c. In cold climates, store portable compressors in a heated building when
not in use. This will reduce problems with motor starting and freezing of
water condensation.
d. Remove the compressor from the carton and place it on the floor or a
hard, level surface. The compressor must be level to ensure proper
drainage of the moisture in the tank.
Figure 2

ASSEMBLY

12 inches
(31 cm)
12- ENG