Operating Instructions - SheerAIRE AC-2064 Guía De Uso Y Cuidado

OPERATING INSTRUCTIONS

NOTE: Before operating the air purifier, record the date of installation
on the HEPA filter. Under normal use conditions (12 hours a day), the
HEPA filter should be replaced once a year, and the pre-filter should be
replaced every 3 months. To remove and replace either filter, see "Filter
Replacement" in "Care and Maintenance."
1. Check the Air Purifier filters. Before turning unit on, be sure all filters
are correctly in place, and that any plastic packaging has been removed
from filters.
2. Place the Air Purifier on a hard surface such as the floor, table, or desk.
Be sure the grills are not blocked by other objects and that there are
no candles or flames near the unit. The Air Purifier can be positioned
upright or on its back in a horizontal position for operation.
3. Plug into the nearest standard electrical outlet.
4. Turn the FAN Speed/POWER Dial to LO to turn the air purifier on.
Turn the FAN Speed/POWER Dial to OFF to turn the air purifier off.
5. When the air purifier is turned on, adjust from low to high speed by
turning the FAN Speed/POWER Dial.
6. Use the FILTER CHANGE INDICATOR RESET button to reset the HEPA
Filter and Pre-Filter Change Indicators. Each Indicator will illuminate
when each of the filters may need to be replaced. To reset, press and
hold the FILTER CHANGE INDICATOR RESET button until the Change
Indicator Light is no longer on. If both Lights are on at the same time,
and only one of the filters is changed, pressing the FILTER CHANGE
INDICATOR RESET button will turn off and reset both Indicator Lights.
NOTE: When both Indicators illuminate, replace the HEPA Filter and
Pre-Filter at the same time.
7. Choose to activate or deactivate the Ionizer. The Ionizer provides
additional air freshness through the release of negative ions.
To activate, press the IONIZER button. To deactivate, press the
IONIZER button again and the light no longer appears.
5