Install The Camera In The Housing - Axis T92A00 Guia De Instalacion

Page 6

Install the camera in the housing

3
AXIS T92A00 comes with a pre-installed power supply.
1. The housing is shipped with 3 black plastic spacers. Use one, two or three spacers between the
camera and holder and make sure that the camera lens is positioned more than 2mm above the
heater and that the cables are not in contact with the heater:
• AXIS P1311 - 1 spacer
• AXIS Q1755 - 1 spacer
• AXIS 210/210A - 2 spacers
• AXIS 211/211A/211M/211W - 2 spacers
• AXIS 221/223M - 1 spacer
2. Secure the camera, spacer(s) and holder with one of the three screws (flathead) and clear
plastic spacer (fig.1).
3. Fit the slots on the holder to the positioning screws (fig.2).
4. The camera should be positioned so the lens is 1-2mm from the housing window. Slide the
holder to a suitable position and tighten the positioning screws when satisfied.
FIG.1
Axis Network
Camera
Holder
Flathead screw
Positioning
screws for
holder
5. Proceed to "Connect the power cable to the camera" on page 7.
Rectangular
spacer(s)
Clear plastic spacer
FIG.2
Heater
positioned here
AXIS T92A00 Installation Guide