Casals HA150032QEAK Manual De Usuario página 7

- Insert the tool by moving the sliding ring (B)
back. Now the SDS-plus chuck is open.
- Install the tool in. Turn it slightly until it can be
pushed in all the way and you can feel it en-
gages into place.
- Release the sliding ring (B). Now the tool is
locked.
SDS-plus adapter for drilling in wood or
metal (Fig. 3)
- Unplug the appliance from the mains.
- Fit the SDS-plus adapter (K) into the SDS-plus
tools"
- Screw the Drill Chuck (J) on the mounting
have shaft and Screw the mounting Screw.
also - Open the drill chuck (J), whilst the device is
ssis- completely switched off.
- Insert the cilindrical drill bit, or other tool/ ac-
cessory required for the task, into the chuck (J).
In order to obtain a secure fastening of the bit,
insert the bit as far as you can into the chuck.
iliary - Close the drill chuck (J), whilst the device is
completely switched off.
. - Don't use rotation with hammering when the
e into SDS-plus adaptor + drill chuck is installed on
the device.
unter
Using the dust collector (Fig 2)
- The dust collector is used for drilling into ceil-
ings.
- Side the dust collector (I) onto the shaft of the
g has bit and mount the bit as described above "Fit-
ting the working tools".
func-
Electronic speed control (Fig 1)
- The speed of the appliance can be regulated
by using the speed regulator control (H). This
function is very useful, as it makes it possible to
adapt the speed of the appliance to the type of
work that needs to be done.
- If the appliance works continuously at low
speed, working life of the appliance will be re-
duced considerably.
Use:
- Connect the appliance to the mains.
- Select the appliance function desired (Fig 1)
Hammer drilling with rotation
- Set the selector (D) to (
- Turn the selector (C) until the arrow on the ap-
pliance points to (
Drilling without hammer action
- Set the selector (D) to ( )
- Turn the selector (C) until the arrow on the ap-
pliance points to (
Chisel without rotation
- Set the selector (D) to (
- Turn the selector (C) until the arrow on the ap-
pliance points to ( )
- Place the appliance against the surface you
want to work.
- Press the appliance until the lengthways play
is taken up.
- Turn the appliance on, by using the on/off but-
ton (E).
Note: Exerting high pressure does not increase
machine effectiveness!
WARNING: When the bit begins to penetrate
concrete or comes up against the reinforce-
ment rods in the concrete, the tool may react
dangerously. Make sure you keep your balance
by distributing your weight evenly and keeping
your feet in a safe position whilst holding the
actions.
)
)
)
)
-
7