Warnings For Installation; Electrical Connections - LaserLine LM87X Manual De Instalación

!
Thank you for your trust and your decision to purchase this top-quality device. Laserline is
one of the leading manufacturers of alarm automotive sector. We are sure that you will be
completely satis ed with this device.
All the electrical connections must be done by quali ed personnel in a reliable and secure
mode.
• RED WIRE: connect to the positive of services valve, inserting a fuse.
• BLACK WIRE: alarm ground, connect to a motorcycle ground.
• PURPLE WIRE : connect to a positive ignition key. On this wire must always be present a
positive, both in the starting phase that with motor on.
• YELLOW WIRES: connect one wire to the direction indicators of left side and the other wire to
the direction indicators of the right side.
• WHITE/BROWN WIRE: programmable negative output. See programmable functions.
This output can be programmed in the following ways:
1) Factory setting (Negative during alarm), every time that will be generated an alarm condition,
on this wire will be present a negative signal for all the alarm cycle (30 seconds).
2) Customized setting
there will be a negative signal on the wire allowing you to activate an additional module (optional).
The negative signal will expire disarming the alarm with the remote control.
• BLUE WIRE: negative programmable input. See programmable functions.
This input can be programmed in the following ways:
1) Factory setting (Input switch stand / saddle): with armed alarm, every opening of the protected
areas (stand / saddle) will generate an alarm condition.
2)Customized programming (Command anti-robbery), with disarmed alarm and with the
motorcycle O , every ground signal (provided with a button previously connected) will activate N
the anti-robbery function signalled by a short ash of the direction indicators.
• GREEN, GREEN-BLACK, GREEN-YELLOW WIRES: connect only 2 wires to make the safety
lock of the motorcycle. It's necessary follow the more appropriate schematic connections
2B depending on the type of plant of the motorcycle.
NOTE: the engine lock is active when is present a positive signal on the Yellow wire (starting key).
• RED, BROWN WIRES: connected to a dedicated connector for the status LED of the alarm.
• WITHE-RED, BROWN WIRES: connected to a dedicated connector for the electronic socket.

WARNINGS FOR INSTALLATION

ELECTRICAL CONNECTIONS

(Output for module): arming the alarm by remote control, after 5 seconds,
1 Positive
2 Button stand/saddle
3 Electronic key
4 LED positive
5 Direction indicator
6 Direction indicator
7 Negative
8 Positive
9 Lock engine
10 Lock engine COM
11 Lock engine NA
12 Negative alarm command
ignition key
NC
10
12V Red wire
Blue wire
White-Red wire
Red wire
Yellow wire
Yellow wire
Black wire
Purple wire
Green-Black wire
Green wire
Green-Yellow wire
White-Brown wire
2A or