Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation, Setup and Operation Guide
EBA and EBB EXPANSION BOARDS
I. SAFETY NOTICES
ATTENTION
- WARNING: NEVER touch any of the electrical components directly when equipment is
removed from package.
- The serial interface RS-485 can not be used simultaneously with the serial
interface RS-232 .
II. GENERAL INFORMATION
This guide provides information for the correct installation, configuration and
operation of
EBA and EBB Expansion Boards in the CFW-09
the models described in Table 1. This table describes the functions of the boards and the
existing differences between the models.
Table 1: Models of EBA and EBB optional boards and their respective functions.
FUNCTIONS
Encoder signals Input
Isolated internal power supply for encoder (12 V)
Encoder signals Output
Serial interface RS-485
Differential Analog Input
Differential Analog Output
Isolated Analog Input
Isolated Analog Output
Digital Inputs and Output for optional thermistor PTC
*1 - In this model the encoder is supplied by internal 5V source.
III. PACKAGE CONTENT
- 1 Expansion Board packaged in anti-static plastic sheets.
NOTE
- Check if the model indicated on the package label matches the ordered ones.
- Remove the Expansion board from the anti-static plastic package carefully.
- Hold the board only on the sides. Do not touch directly on the components.
1. EBA/EBB BOARD INSTALLATION
The EBA/EBB board is installed on the CC9 control board, secured by spacers and
connected via terminal blocks (connectors) XC11 (which supplies the expansion board with
24V) and XC3.
. This guidance applies to
BOARD MODELS
EBA
EBB
01 02 03 01 02 03 04 05
1
Tabla de contenido
