BABYTREND ST28C20A Manual De Instrucciones página 4

ASSEMBLY
REMOVABLE BUMPER BAR
WARNING:
use bumper bar to carry seat
with child inside. The bumper
bar is not a carrying handle.
5) • Attach the bumper bar by lining up
anchors with the slots on the seat. Push
until it clicks into place (Fig. 5a).
NOTE: The bumper bar must be securely
attached before using this product.
• To access the child seat, press the
release button and pull bar out of the
anchor. Swing the bar upwards to access
the seat (Fig. 5b). Press both buttons
simultaneously and pull out to remove the
bumper bar (Fig. 5c).
SEATBACK POSITIONING
6) • To recline the seat press the clip ends
together and pull it down. To put seat into
the upright position, press the clip ends
together, hold the hoop and push the clip
up (Fig 6).
NOTE: The upright position should be
used only for a child that is at least 6
months old. Always re-adjust the safety
harness, including the shoulder belts when
repositioning the seatback.
5
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Do not
Fig. 5a
Fig. 5b
Fig. 5c
Fig. 6
ADJUSTING THE LEG SUPPORT
7) • Lift to raise the leg support. Press the
buttons on both sides of the leg support
to lower (Fig. 7).
CUP HOLDER
WARNING:
To avoid
burns, never put hot liquids
in cup holder. Avoid possible
tipping, do not place more
than 1 lb. (0.45kg) in cup
holder.
8) • To attach cup holder: slide the clip on the
cupholder over Cup Holder tabs on the
Handle Bar. Push untill firmly in place
(Fig. 8).
STORAGE BASKET
9) • Under the basket, completely close the
three snap buttons and make sure to tuck
the cable under the flap (Fig. 9).
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 7
Fig. 8
6
Fig. 9