Battery Change; Changing The Battery; Turning The Power Meter On And Off; After A Crash - power2max NGeco Manual De Usuario

BATTERy CHAnGE

To change the battery, remove the battery cap (no tool needed). Pull out the empty battery
and insert a new battery. Pay attention to the correct position of the positive pole and
negative pole. Close the battery cap and check if it is in the correct position.

TURnInG THE POWER METER On AnD OFF

eco
You can turn off your power2max NG power meter yourself by removing the battery.
eco
You can turn your power2max NG power meter back on by inserting the battery again.
nOTE:
eco
When transporting your bicycle, the power2max nG power meter is activated. Therefore, it is
recommended to turn off the power meter for longer transports. you should generally turn it off
when transporting your bike in a plane.

AFTER A CRASH

eco
The power2max NG power meter was developed to have a high level of reliability. Usually,
crash forces are generally completely absorbed by the crankarms and the bottom bracket.
eco
Crash damage to a power2max NG power meter is thus almost completely ruled out.
In the interest of your own security and health, you should do the following checks:
Could the cranks have sustained any damage? The cranks could suffer from hairline frac-
tures that you may eventually not recognize. This could, over time, result in sudden failure.
Therefore, replacement is recommended. If anything is rattling around the crankset, this
could indicate potential damage. Examine all mechanical connections.
24